OpenNode > Installation and Configuration

opennode 6.0rc1 install failed

<< < (3/3)

chenlong828:
I have successfully finished the convert process.

During the process, I got these message:

Failed to create a new pool: Failed to execute command 'virsh 'pool-define-as local dir --target /storage/local''. Status: '256'. Output: 'error: Failed to reconnect to the hypervisor
error: no valid connection
error: Failed to connect socket to '/var/run/libvirt/libvirt-sock': No such file or directory
'
  Installing : opennode-6.0-10.x86_64                                                                                 213/217
error: "net.bridge.bridge-nf-call-ip6tables" is an unknown key
error: "net.bridge.bridge-nf-call-iptables" is an unknown key
error: "net.bridge.bridge-nf-call-arptables" is an unknown key
error: "net.ipv4.conf.vmbr0.proxy_arp" is an unknown key
set forward delay failed: No such device

Does it correct?

And the another question, can I use another card for bridge network?

thanks.

chenlong828:
I was starting download the OMS image, and later I will try and report it^^

activesys:
1) These errors are ok - as there is no existing libvirt and bridge - so online modifications fail but they are still configured to be present after reboot

2) You can use whatever network interfaces - just reconfigure vmbr0 bridge members - eg take eth0 out and put something else in.
See brctl help for syntax - in order to manipulate bridge member devices.

Navigation

[0] Message Index

[*] Previous page